Switch Access
8
When the switch is configured through the CLI, "?" can be used to get command help. In the
help information, there are different parameter description formats. For example, <1, 255>
means a number range; <H.H.H.H> means an IP address; <H:H:H:H:H:H> means a MAC
address; word<1,31> means a string range
. In addition, ↑ and ↓ can be used to scroll
through recently used commands.
2.2 Access through Console Port
You can access a switch by its console port and the hyper terminal of Windows OS or other
software that supports serial port connection, such as HTT3.3. The following example shows
how to use Hyper Terminal to access switch by console port.
1. Connect the serial port of a PC to the console port of the switch with a DB9-RJ45 cable.
2. Run the Hyper Terminal in Windows desktop. Click [Start] → [All Programs] →
[Accessories] → [Communications] → [Hyper Terminal], as shown in the following figure.
Figure 1 Starting the Hyper Terminal
3. Create a new connection "Switch", as shown in the following figure.
Summary of Contents for SICOM3024P
Page 13: ...Product Introduction 6 management software and SNMP network monitoring...
Page 25: ...Device Status 18 Figure 15 System Operating Information SICOM3024...
Page 73: ...Advanced Configuration 66 Figure 67 Setting ACL Entry Parameters Group 2...
Page 145: ...Advanced Configuration 138 Figure 137 Dynamic Unicast FDB Table...
