8
4.2 100Base-FX Port
100Base-FX port is equipped with FC/ST/SC connector, and each port
consists of TX (transmit) port and RX (receive) port, as shown in Figure 10.
Figure 10 shows 100Base-FX port wiring. (The following uses the SC port
as example; ST/FC wiring method is the same with SC.) To enable data
transmission between Switch A and Switch B, connect the TX (transmit)
port of Switch A to the RX (receive) port of Switch B, and the RX (receive)
port of Switch A to the TX (transmit) port of Switch B.
Figure 10 100Base-FX Cable Connection
Caution:
The device uses laser to transmit signals in fibers. The laser meets the
requirements of level 1 laser products. Routine operation is not harmful to your eyes, but
do not look directly at the fiber port when the device is powered on.
4.3 1000Base-X SFP Port
To use 1000Base-X SFP port, you need to purchase a gigabit SFP module
(For details, see Table 11). After the SFP module is inserted into the
1000Base-X SFP port, you can connect the device to other devices with
optical fibers for communication.
Figure 11 SFP Module
