Shenzhen KYL Communication Equipment Co., Ltd
Fax: +86-755-83408785
www.rf-data.com
6
6. The Function-indicator light
a. The LED indicator light will glitter red for 0.5S once after switched on.
b. The LED indicator light will glitter green continually while receiving data from
air.
c. The LED indicator light will glitter red continuously when transmitting data into
air after receiving from COM.
d. If the module enables the sleep function, LED indicator light is always dark.
7. Supported protocol and Transmit capability
KYL-300M standard transceivers offer transparent protocol to support various
applications and protocols of users. If the user needs to decrease his cost or ease the
workload of terminal CPU, we can add other specific functions based on the
transparent protocol, such as addressing, data acquisition, command interpretation,
etc.
8. Sleep function instruction:
Due to reducing more consumption, KYL-300M transceivers support Sleep
function. In sleep mode, the current consumption is less than 20uA.
a. How to use the Sleep function:
The Pin8 ‘SLP’ in JP1 is the signal of sleep control. In high power level,
transceiver stays in working mode. In low power level (<0.5V), transceiver stays
in sleep mode. The SLP signal can convert transceiver from working to sleep
mode in 1ms after falling edge. If the Sleep signal arrives when the transceiver is
transmitting data, the module will enter sleep mode after finishing transmission.
From sleep mode to working, it takes the transceiver 1ms after rising edge.
To disable the opened sleep function of KYL-300M, the SLP (SLEEP) pin
should be definitely connected with 0 or ground.
b. Attentions about use of sleep function:
When the sleep function enabled, any supply glitches, such as switch dithering,
fire striking or quick switching on and off, could cause the transceiver to be
switched to the wrong sleep mode.
After switching on, users can avoid this error by making a compulsive
restoration once after the CPU delays 100ms.
Sleep Timing Diagram:
