NX-6550 M/N: GM-130008/S
English
- 2 -
Note:
Download the programmable driver from the Genius website at
Warning: (Troubleshooting)
1.
Do not use the wireless optical/laser mouse on a desk which is made of glass or
mirror.
2.
The connection of the wireless device is
factory preset
, so when you plug the
USB receiver into any USB port, the connection between the micro receiver and
the mouse
will be established automatically
.
3.
In case your PC did not install the hardware successfully, remove the micro
receiver from the USB port and go
Human Interface Devices
under
Device
Manager
to remove the mouse then plug in the micro receiver to a USB port
again.
4.
If you feel the mouse does not move smooth as usual, it is possible the batteries
have lost their charge so you need to replace them. Remember to put the batteries
in the correct direction.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
