1. Prepare the replacement track and spring pliers, and prop up the kwun body to lift the track off the ground, Take out self cleaning stuff.
2. Remove the shaft retaining ring (spring) of the driving wheel and the driven wheel using spring pliers, and remove the outer retaining ring on
the driving wheel and the driven wheel.
3. Reach into the inside of the track and take it out from the inside out to complete the track disassembly.
4. Use the caterpillar to be replaced and install the caterpillar.
5. Put the track into the driving wheel, the slave wheel and the synchronous wheel in turn, and then press the track into the inner retaining ring
of the driving wheel with force, Insert self cleaning stuff.
6. Install the outer retaining ring to the driving wheel and the driven wheel, and use the spring pliers to set the spring in the spring groove of the
driven wheel and the driving wheel respectively.
7. Check to ensure that all driving wheels and external retaining rings of driven wheels are inside the spring grooves to complete installation.
3
3. Introduction
3.5 Water Cube
3.5.1 Water Cube connection
1. Fix the rotating table module base of the Water Cube to the mounting hole of the shell through M4 captive bolts.
2. Insert the nozzle module of the Water Cube into the through hole of the roller brush cover.
3.5.2 External device
3.4 Track installation and replacement
① water inlet
② hydraulic press
③ outlet pipe
④ universal rotary joint
⑤ hose
⑥ water cube
⑦ mainfold
Need to purchase hydraulic press, universal rotary joint
and hose to use together.
Collocation demonstration:
•
M14 external thread to M22 external thread rotary universal rotary joint
•
M14 braided high-pressure hose with 20m length and 8.5mm rotary
joints with internal and external threads
•
900W Hydraulic press (with water inlet and outlet pipe)
