Tool required: a blade screwdriver (allen wrench provided).
1. Unpack carton(s) and identify all parts.
2. Place table top upside down (screw holes up) on a clean, flat, smooth surface.
3. Assemble back panel, two end panels, and front support rail; it is easiest to do this with these
parts upside down on the table top.
FRONT
a. Bolt together back panel and two end panels with six painted matching
screws and Kepsnuts
(three on each side). (if you ordered the TBS60 table with shelf, omit the
one screw on each
side farthest away front the top at this time).
b. Bolt together front support rail with open flange facing inside with angled
side against top; use
four painted matching screws and Kepsnuts (two on each side).
4. Locate the assembled table frame so that the 10 holes in the end and back
panel flanges line up with the 10 pre drilled holes in the top. Insert the sheet
metal screws provided through the holes and tighten into the top. Additional top
screws are self tapping and can be installed without pre-drilling.
5. Using a hammer or rubber mallet, pound the glide insert into the leg. Then
screw the leg glide into the glide insert. Place legs into the leg sleeves at the
corners of the table. Each leg has two threaded holes at the upper end; legs
should be inserted so that the holes line up with the adjustment holes in the leg
socket. Table height can be adjusted between 29" and 36" in one inch
increments.
