KVH Industries TracVision TV3, Installation Manual, Page: 15 / 42

14
Linear Wiring
Follow these steps to connect linear receivers to
the TracVision system
(linear universal single LNB
or linear universal dual LNB required) .
Connecting 1 Receiver
Connect an RF cable from the “Receiver” jack on
the TV-Hub to the “Satellite In” jack on the
receiver (see Figure 24).
This receiver will be able to
control satellite selection in Automatic satellite
switching mode.
Connecting 2 Receivers (Dual Linear System Only)
a. Run a second RF cable (RF2) from the
antenna (see “Wire the Antenna” on page 8 ).
Be sure to connect a grounding block in-line
with the RF1 and RF2 cables from the antenna
(see Figure 25 and “Grounding
Requirements” on page 20 ).
b. Connect an RF cable from the “Receiver” jack
on the TV-Hub to the “Satellite In” jack on the
first receiver. This receiver will be able to control
satellite selection in Automatic satellite switching
mode.
c. Connect the RF2 cable from the grounding
block to the “Satellite In” jack on the second
receiver (see Figure 25).
Figure 24: Wiring 1 Linear Receiver
TV-Hub
Antenna
Receiver
AC Power
Satellite In
Receiver
RF1
Figure 25: Wiring 2 Linear Receivers (Dual Linear System Only)
TV-Hub
Antenna
Receiver
AC Power
Satellite In
RF1
Receiver
AC Power
Satellite In
RF2
Grounding
Block
Receiver
To enable the second receiver to control
satellite selection, install an optional IP
AutoSwitch (KVH part no. 72-0634) in-line
with the receiver’s RF input. See Appendix A
on
page 31 for details.
IMPORTANT!
Continued
Wire the Receivers
11