22
DIRECTV Latin America Wiring
Follow these steps to connect DIRECTV Latin
America receivers to the TracVision system.
NOTE:
The DIRECTV L.A. circular LNB is required
(KVH part no. 72-0906).
Connecting 1 Receiver
Connect an RF cable from the “Receiver” jack on
the TV-Hub to the “Satellite In” jack on the
receiver (see Figure 33).
Connecting Multiple Receivers
a.
Run a second RF cable (RF2) from the
antenna (see
Be sure to connect a grounding block in-line
with the RF1 and RF2 cables from the antenna
b.
Connect the RF2 cable from the grounding
block to the “13V” jack on the power inserter
(
supplied in kit
).
c.
Connect the “V-OUT” jack on the power
inserter to the “18V” jack on the multiswitch
(
supplied in kit
).
NOTE:
If you need to connect more than four
receivers, install a multiswitch that has more outputs.
KVH offers an 8-output multiswitch (KVH part no.
72-0310).
d.
Set the power inserter’s switch to the
“17/18V-HORZ, 13/14V-VERT” position.
e.
Connect the “Receiver” jack on the TV-Hub
to the “13V” jack on the multiswitch.
f.
Connect the multiswitch outputs to the
“Satellite In” jacks on the receivers.
g.
Terminate any unused outputs on the
multiswitch with 75
terminators and verify
all connections are tight.
TV-Hub
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B
A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
AC Power
DIRECTV L.A. Receiver
Satellite In
Receiver
Antenna
RF1
Figure 33: Wiring 1 DIRECTV Latin America Receiver
Figure 34: Wiring Multiple DIRECTV Latin America Receivers
TV-Hub
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B
A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
Power
Inserter
Connect up to 4 receivers
Terminate
unused
outputs
Grounding
Block
Receiver
Antenna
AC Power
Satellite In
18V
13V
RF1
RF2
13V
V-OUT
AC Power
DIRECTV L.A. Receiver
13V
18V
Multiswitch
Set switch to:
17/18V-HORZ.
13/14V-VERT.
Continued
Wire the Receivers
11
Summary of Contents for TracVision TV10
Page 1: ...TracVision TV10 Installation Guide ...
Page 53: ......
