KVH Industries TracVision TV10, Installation Manual

Page: 21 / 54

20
DIRECTV – SWM Wiring
Follow these steps to connect DIRECTV SWM
receivers to the TracVision system.
NOTE: The stacked circular LNB (supplied in kit) is
required. Refer to “Installing a Circular LNB” on
page 37 .
Connecting 1 SWM Receiver
Connect an RF cable from the “DSWM” jack on
the TV-Hub to the “Satellite In” jack on the
receiver/DVR (see Figure 30).
Connecting Up to 8 SWM Receivers (or 13 Tuners)
a. Connect an RF cable from the “DSWM” jack
on the TV-Hub to the “SWM” input on the
SWM splitter ( supplied in kit ) (see Figure 31).
b. Connect the SWM splitter’s outputs to the
“Satellite In” jack on the receivers/DVRs.
You can connect up to 8 SWM devices that
add up to 13 or fewer tuners. Refer to
Figure 31 to determine the tuners consumed
by each type of device.
c. Terminate any unused outputs on the SWM
splitter with the supplied 75

terminators
and verify all connections are tight.
Figure 30: Wiring 1 DIRECTV SWM Receiver
TV-Hub
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
AC Power
SWM Receiver
Satellite In
Antenna
RF1
DSWM
Figure 31: Wiring Up to 8 SWM Devices
Wi-Fi
LEN=1
10-30V
POWER
MAX CURRENT 9.5A
NMEA 0183
B A
FUSE
ETHERNET
DSWM
RECEIVER
GROUND
ANTENNA
RESET
NMEA 2000
DC IN
TV-Hub
AC Power
SWM DVR
Satellite In
AC Power
AC Power
SWM DVR
AC Power
SWM Receiver
Satellite In
Satellite In
Connect any combination of
SWM 8-way
Splitter
Terminate
unused
outputs
DSWM
SWM DVR
Satellite In
AC Power
SWM Receiver
Satellite In
SWM receivers/DVRs that add
up to 13 or fewer tuners
Each SWM receiver = 1 tuner
Each SWM DVR = 2 tuners
If you need to receive local channels on the
119W satellite, and you want the antenna to
automatically switch between the 101W and
119W satellites, you need to use the DIRECTV
coax network. See Appendix C on
page 45 for
details.
IMPORTANT!
Continued
Wire the Receivers
11