KVH Industries TracVision RV1, Installation Manual, Page: 12 / 38

11
The steps for connecting the customer’s
receiver(s) to the TracVision system and setting
them up depends upon the customer’s satellite
TV service (see Figure 15 and Figure 16).
NOTE: KVH’s TracVision Configuration Wizard,
available at www.kvh.com/rv1configurator , displays a
wiring diagram and parts list for all of the most
common configurations.
Follow the steps in the applicable section below
to wire the receivers. Then connect the receiver(s)
to the customer’s television(s).
Linear . . . . . . . . . . . . . . . . . . . . . . . . page 12
DIRECTV (SWM) . . . . . . . . . . . . . . page 13
DIRECTV (Non-SWM) . . . . . . . . . page 14
DISH Network/Bell TV . . . . . . . . page 15
TV-Hub A
DIRECTV U.S.
Non-SWM Receivers
DISH Network, Bell TV,
and Linear Receivers
DIRECTV U.S.
SWM Receivers
Figure 15: TV-Hub A Receiver Connections
TV-Hub B
Linear Receiver
Figure 16: TV-Hub B Receiver Connections
Wire the Receivers
9