9
5.
Be sure to perform
all
other steps in the
installation guide that follow the initial ICM
preparation, mounting, and wiring steps,
including the following:
• Connect the ICM Jumper Cable (see
• Attach the Wi-Fi Antennas (see Figure 19).
• Connect the RF Terminator (see Figure 20).
Figure 19: Jumper Cable and Wi-Fi Antenna Connection
ICM
Wi-Fi Antenna (x2)
B1
B2
Figure 20: RF Terminator and Instructions Tag
ICM
B2
J4 Rx RF
IMPORTANT!
Install RF Terminator P/N 19-0972 on this fitting!
To prevent damage tighten all cable connectors
finger tight, then turn no more than 1/8 turn
using7/16 wrench (not to exceed 15 in-lbs
torque).
Improper cable installations are not
covered under KVH warranty.
Install RF Terminator
Remove & Read
