Operation
72
Single rotor
operation
The single rotor operation work position makes it possible to deposit
the crop using the rotor on the right-hand side.
Switch off the tractor and secure it.
Disconnect the PTO shaft of the inactive, left-hand rotor from the
PTO stub shaft.
Place the PTO shaft in the stowage well.
Using the lift limiter, lift both rotors out until they are secured by the
lift limiter.
Release the right-hand rotor using the control cable and lower it
using the tractor's hydraulic control device.
Switch on the drive for the PTO shaft.
During a changeover from single to dual rotor operation, make sure
that the PTO shaft locks in place.
Finishing single rotor
operation
Switch off the PTO shaft drive.
Use the lift limiter to lift the rotors out until they are both secured by
the lift limiter.
Using the tractor's hydraulic control device, pull the release cords
and relieve the lift limiters of load to make it possible to release the
lock of the lift limiters.
Use the tractor's hydraulic control device to lower both rotors into
the work position.
Remove the PTO shaft from the stowage well on the transmission
console.
Fit the PTO shaft of the inactive, left-hand rotor and lock it in place.
Single swath with right rotor
Switch off the tractor and secure it
Before you dismount, switch off the tractor and secure it against
rolling away. An unsecured tractor and machine may run you over
or trap you. Serious or fatal injury may be caused as a result.
Summary of Contents for VF6585
Page 100: ...EC Conformity Declaration 100 ...
