![KUULAIRE PACKA34 Owner'S Manual Download Page 3](http://html.mh-extra.com/html/kuulaire/packa34/packa34_owners-manual_2012600003.webp)
COOL
Dampen a clean cloth with water and use it on the exterior
of the unit to remove any dust or dirt. Never use harsh
detergents, solvents, and corrosive cleaners to clean the unit.
When not in use, drain the water reservoir and store the unit
in an area where it is dry and out of sunlight.
MAINTENANCE:
Regular draining, at least once each week, will decrease the
water mineral build up and extend the life of the honey-comb
media pad. A damp cloth can be used to remove calcium build-
up inside and outside of the unit. The dust filter/cover can be
removed easily and can be cleaned weekly. The inside of the
water reservoir can be cleaned once or twice in a season to
maintain air quality.
DEEP CLEAN:
Remove screws holding the rear panel and remove the rear
panel by unhooking the tab located in the top of the rear panel.
Wash cooling pad with water and soft bristled brush to remove
debris and mineral build-up. Fill up the reservoir with fresh
water and drain. Repeat the procedure to remove debris and
mineral build-up in the reservoir.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
WARNING: Unplug the unit from power
outlet prior to moving or servicing, or
filling or draining the water reservoir.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
ON/OFF
1. Connect the cord to a power outlet.
2. Press the ON/OFF button to turn on the unit. Indicator
light will illuminate. To turn off, press the ON/OFF button
again.
SPEED
Press the SPEED button to select the desired fan speed.
The selected fan speed indicator LED light will light up.
Fan speed settings are LOW – MID – HIGH.
MODE
Press the MODE button to select the desired fan mode.
The selected fan mode indicator LED light will light up.
When SLEEP or NATURAL is selected, air speed will change
randomly.
COOL
To use the unit as an evaporative cooler, press the COOL
button. The pump will start and distribute water to wet
out the cellulose media located in the rear of the unit.
After approximately three minutes, as the pad becomes
saturated, the air from the outlet should be cool.
LOW WATER ALARM FUNCTION
The PACKA34, PACKA34-22050, PACKA34-22060, PACKA44,
PACKA44-22050, PACKA44-22060 are equipped with a low
water sensor alarm. When water in the reservoir is below
minimum level, you will hear audible beeps and COOL LED
indicator will flash continuously. At the same time the
power to the pump will be cut off to protect the life of
the pump. In order to disengage the alarm function, turn
off and unplug the unit from the power outlet, and fill the
reservoir with water above the minimum level. In order to
turn off the alarm function and continue to use it in FAN
mode, press COOL button again. If COOL button is pressed
again without filling the reservoir with water, low water
alarm will go off again.
SWING
Press the SWING button to direct the air stream. The
vertical louvers will begin to move automatically from
side to side. The indicator LED will come on. To adjust the
vertical direction of air flow, adjust the horizontal louvers
manually.
TIMER
The unit comes with an 0.5 hour to 7.5 hour. To set, press
the TIMER button to the desired operation time. When the
pre-selected time has elapsed, the unit will automatically
shut off. In order to cancel the TIMER program, press and
hold TIMER button until time indicator lights are turned off.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
Water Reservoir Capacity
11 Liters/3 gallons
Dimensions (cm)
65 H x 39.7 W x 30 D
Dimensions (inches)
25 H x 16 W x 12 D
Net Weight
6.0 kg/14 lbs.
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
▲
!
Model No. PACKA34
(110-120V 60Hz, 70W)
Model No. PACKA34-22050
(220-240V 50Hz, 70W)
Model No. PACKA34-22060
(220-240V 60Hz, 70W)
ON/OFF – start or turn off the unit
Timer – timer from 0.5 hour to 7.5 hours
Cool – start water pump
Speed – Low/Medium/High
Swing – automatic swing of louvers
Mode – Sleep/Natural/Normal
COOL
PACKA34 and PACKA44
CONTROL PANEL
9/26/2011
COOL
Model No. PACKA44 (110-120V 60Hz, 115W)
Model No. PACKA44-22050 (220-240V 50Hz, 115W)
Model No. PACKA44-22060 (220-240V 60Hz, 115W)
Water Reservoir Capacity
15 Liters/4 gallons
Dimensions (cm)
72 H x 39.7 W x 30 D
Dimensions (inches)
28.3 H x 16 W x 12 D
Net Weight
6.7 kg/14.8 lbs.