Kustom PA2X6BT, Owner'S Manual

Page: 7 / 14

Peak Output Power 200W 4 ohm load
CH1 and CH2 Mic XLR Balanced, Line Level 1/4" Un-balanced
Ch3 1/8" Line Level or Bluetooth Device
-56dB Residual Noise, all level controls 0% (mimimum)
-48dB Nominal System Noise, all level controls at 50%
+70dB Mic to Speaker Output (CH 1 & CH2)
+56dB Line to Speaker Output (CH1 & CH2)
+42dB Aux In to Speaker Output
Channel EQ (high, low)
Subwoofer Out Line Out 20 Hz-150Hz
Monitor Out
Line Out Balanced TRS Output with grounded sleeve
Phantom Power +15V Mic inputs (CH1 & CH2)
USA/Canada 120VAC/60Hz, 160W nominal
Europe 230VAC/50Hz, 160W nominal
UK 230VAC/50Hz, 160W nominal
Australia 240VAC/50Hz, 160W nominal
Japan 100VAC/50-60Hz, 160W nominal
Speakers Two 6" 8 ohm each
Horn
Frequency Response
80Hz-20kHz
Full range (subwoofer jack not used)
Subwoofer Crossover 150Hz-20KHz Crossover Active (1/4" mono plug in subwoofer jack)
Nominal Impedance 4 ohm Not designed for external speakers
Dimensions & Weight
mm/kg 240mm D x 205mm W x 550mm H / 10.20 kg
Inches/Pounds
9.5" D x 8" W x 21.65" H / 22.5 lbs
PA2X6BT Specifications
Hum & Noise
Accepted Inputs
1" Neodymium Compression Driver
Bluetooth Module Features
Bluetooth 3.0+EDR compliant. T2dBm Class 2 output
power. Audio DAC:94dB SNR. A2DP profile support
System Gain/Speaker Output
(Measurement made at 1kHz)
4kHz and above, 800Hz and below
SYNC (IN and OUT)
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two Kustom models
Power Requirements