Kustom PA150TFX, Owner'S Manual, Page: 8 / 12

Output Power 1% 2 x 75W 2 x 4 ohm load
CH1 and CH2 Mic XLR Balanced, Line Level 1/4" Un-balanced
Ch3 1/8" Line Level or Bluetooth Device (150TFXBT models)
-46dB Residual Noise, all level controls 0% (mimimum)
-37dB Nominal System Noise, all level controls at 50%
+49dB Mic to Speaker Output (CH 1 & CH2)
+35dB Line to Speaker Output (CH1 & CH2)
+25dB Aux In to Speaker Output
Channel EQ (high, low)
Subwoofer Out Line Out 20 Hz-150Hz
Monitor Out
Line Out Balanced TRS Output with grounded sleeve
Phantom Power +15V Mic inputs (CH1 & CH2)
USA/Canada 120VAC/60Hz, 300W nominal
Europe 230VAC/50Hz, 300W nominal
UK 230VAC/50Hz, 300W nominal
Australia 240VAC/50Hz, 300W nominal
Japan 100VAC/50-60Hz, 300W nominal
Speakers Four 4 1/2" 50W 8 ohm each
Horn
Power Capacity
150W RMS
60Hz-20KHz Full range (subwoofer jack not used)
150Hz-20KHz Crossover Active (1/4" mono plug in subwoofer jack)
Nominal Impedance 4 ohm x 2 Not designed for external speakers
mm/kg 190 W x 715 H x 165 D/11.3 kg
Inches/Pounds 7.5 W x 28 H x 6.5 D/25 lbs
Dimensions & Weight
3 1/2" Piezo Driver
Bluetooth Module Features
Bluetooth 3.0+EDR compliant. T2dBm Class 2 output
power. Audio DAC:94dB SNR. A2DP profile support
Frequency Response
System Gain/Speaker Output
(Measurement made at 1kHz)
4kHz and above, 800Hz and below
SYNC (IN and OUT)
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two PA150's
Power Requirements
PA150TFX/PA150TFXBT Specifications
Hum & Noise
20HZ-20kHZ Actual response is tailored to speaker cabinet for accurate
acoustical response
Accepted Inputs
Frequency Response