INSTALLATION INSTRUCTIONS
I. INSTALLATION
1. Follow instructions for installing the Auto Eject.
2. Place the template in position and center punch in 6 places, see Figure 1: Hole Template.
3. Drill 4 mounting holes, 3/16” diameter, one 1-3/4” clearance hole for the Super Auto Eject, and
one 13/32 hole for the indicator wiring cable.
INTRODUCTION
The new Super Auto Eject Deluxe Cover incorporates two products into one easy to install package.
The Deluxe Cover features a remotely mounted bar graph display. The display contains a 10-LED
bar graph to indicate the vehicle’s battery charger status when used with a Kussmaul Auto Charger.
The top or bottom LEDs blink to indicate HIGH voltage or LOW voltage, respectively. A green LED
indicator illuminates whenever AC power is applied to the Kussmaul Battery Charger.
The new lid design provides for 180-degree motion. This all-in-one package can be easily installed
into existing and new Auto Eject installs.
FEATURES
I. NEW COVER DESIGN
• Incorporates Auto Eject cover and Bar Graph Display into one product
• Lid on cover opens 180-degrees to prevent beakage
• 10-LED bar graph provides Auto Charger status
• Includes rear mounted premolded rubber gasket for extra protect from the elements
II. INCORPORATED BAR GRAPH DISPLAY
When used with Kussmaul Auto Charger, the bar graph indicates the output condition of the charger.
10-LEDs will fully illiminate once the charger output decreases to less than 10%. Should the output
voltage exceed the chargers specifcations, the top LED will blink indicating HIGH voltage. Additionally,
if the battery voltage is too low, the bottom LED will blink indicating LOW voltage.
III. AC Power
A green LED will illuminate whenver AC power is applied to the Kussmaul Auto Charger.
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
2
II. HOLE TEMPLATE: Figure 1
Note:
When printing this page use the print setting “Actual Size”, otherwise template may not print
to scale.
