Startup and Test
1. To Start up and Test the Auto Power Remote Panel:
2. Turn the inverter ON using the Auto Power unit’s Inverter Enable ON itch button on its front panel.
3. Verify the POWER indicator light on the unit and the status indicator light on the remote are ON.
4. Press the ON/OFF button on the remote panel to turn the inverter OFF.
When the remote panel is used with the Auto Power Inverter/Charger the status indicator light will display the following:
• Solid
(green light is on): Normal operation. This means the inverter is enabled/on.
• None
(green light is off): It means the inverter charger is disabled/off.
To test the Ignition Lockout feature (when enabled):
1. Turn your vehicle’s ignition switch to the ACC position. Consult your vehicle’s Owner’s Manual for information.
2. Proceed with the “Startup and Test” procedure above.
Note:
If the vehicle’s ignition switch is OFF or if the red ACC wire is not connected properly, the inverter will not turn ON even after
performing the “Startup and Test” procedure above.
170 Cherry Avenue
West Sayville, NY 11796
www.kussmaul.com
Ph: 800-346-0857
Fax: 631-567-5826
All products of Kussmaul Electronics Company Inc. are warranted to be free of
defects of material or workmanship. Liability is limited to repairing or replacing
at our factory, without charge, any material or defects which become apparent in
normal use within 3 years from the date the equipment was shipped. Equipment
is to be returned, shipping charges prepaid and will be returned, after repair,
shipping charges paid.
Kussmaul Electronics Company, Inc. shall have no liability for damages of any
kind to associated equipment arising from the installation and/or use of the Kuss-
maul Electronics Company, Inc. products. The purchaser, by the acceptance of
the equipment, assumes all liability for any damages which may result from its
installation, use or misuse, by the purchaser, his or its employees or others.
WARRANTY POLICY
