3
INSTALLATION
The Auto Charge Dual 12 Volt-10 Amp Automatic Battery Charger should be installed in an
area with adequate ventilation. Wiring is illustrated in figure 1 and figure 2.
1. Mount the charger using the four holes provided for this.
2. Connect the wiring from the batteries to the Output Terminal Strip.
3. Double- check all wiring before proceeding.
4. Connect the A.C. power through the provided line cord (attached to the charger).
5. Pilot light will show that the charger has power.
Figure 2 illustrates this charger connected to two batteries in series. Each battery is
individually charged and charging ceases automatically when that battery is fully charged.
Thus if battery 1 requires more charging due to the accessory load, charging to battery 1 will
continue even after charger 2 has stopped charging battery 2. This ensures that both
batteries will be fully charged but neither will be over-charged.
