START-UP
Turn the main gas valve to open position.
Turn the gas button to lighter position “
” by pushing it gently. In this
position, ignite the pilot burner with lighter.
After the pilot is ignited, keep the button pressed for a few seconds min. 10) to
heat the safety thermocouple end.
Later, you can adjust it to the desired position by turning to high flame “
”
or low flame “ ” marks indicated on button.
If the device is operated for the first time, keep the button pressed at pilot
burner flame position for a while before ignition to discharge the air in the gas
installation.
TURNING OFF
Turn the gas button to lighter position “
”. In this position, only pilot
burn occurs. Turn to position “0” to turn off completely.
MAINTENANCE
Never perform maintenance without closing the main gas valve of the device.
Before it cools down completely, wipe the device with a cloth immersed in
warm soapy water.
Do not use cleaning substances and tools that may cause scratches on device
surface.
If required, use chemical cleaners.
Do not clean the device with pressurized water or vapour.
If the device will not be used for a long time, coat the surfaces with a thin
layer of Vaseline.
ATTENTION:
Any part replacement that may affect safety must be carried out by
the authorized people.
During maintenance and repair, keep the main gas valve
closed and keep away fire.
Always perform leakage check after repair or part
replacement; use foam or gas detector for this aim.
In case of any dangerous
condition with the device, notify to the authorized service.
Do not allow unauthorized
people to interfere in the device.
DANGEROUS:
Never allow leakage check to be performed with flame.
