Connecting to Your Audio System
The Audio (LEFT/MONO and RIGHT) Jacks
GS-8
GETTING STARTED GUIDE
The Audio (LEFT/MONO and RIGHT) Jacks
Please refer to “Connecting to Your Audio System” below.
The Headphones Jack
Use the Headphones jack to listen to the Artis on stereo headphones.
The headphone jack is located on the left rear panel of the instrument on the Artis7, and on
the left front panel of the Artis.
You will need a 1/4-inch-to-1/8-inch adapter in order to use headphones that have a smaller
mini plug connector.
Connecting to Your Audio System
After you’ve turned down the level on your sound system, connect the Artis analog audio
outputs to your sound system using a pair of balanced (TRS or “stereo”) or unbalanced (TS or
“mono”) audio cables. Unbalanced cables will always work, but if you’re going into balanced
inputs, use balanced cables for a better signal-to-noise ratio and a bit more volume. The Artis
analog outputs are balanced.
You’ll find two 1/4-inch balanced audio output jacks on the
rear panel. Connect one end of
each audio cable to your mixing board or PA system inputs, and connect the other end to the
jacks marked Left (Mono) and Right on the rear panel of the Artis. If you have only one input
available, use the Artis’ Left (Mono) output to get the full signal in mono. Use the jack marked
Headphones to listen to Artis on headphones. When headphones are plugged in, sound still
comes through the Left and Right audio jacks. (
NOTE: Artis7 headphone jack is located
on the rear panel.
)
Artis connected to powered speakers and headphones
