Kurt MX350 MaxLock, Operating Instructions Manual

Page: 12 / 16

12 ENGLISH | Replacement of 5/8 - 11 Threaded Rod
Replacement of 5/8 - 11 Threaded Rod
When reassebling the
hex drive (drive screw)
to threaded rod, thread
(2) 5/8 - 11 nuts onto the
new threaded rod. 1/4 - 20
tapped hole should extend
about 1 - 1/2” beyond nuts.
Tighten jam nuts on
threaded rod. These
will allow you to clamp
threaded rod in vise without
damaging threads.
With nuts clamped in vise
install the hex drive (drive
screw), #MX350-293 and
torque to 120 ft. - Ibs.
Install 1/4 - 20 cap screw and
torque to 200 in. - Ib.
1.
2.
3.
4.