QuickGene-810 Operation Manual
Rev. 1.7
31
4 Maintenance
1
3
2
5
4
6
7
4
Maintenance
This chapter describes how to maintain the QuickGene-810.
4.1 Before Using the QuickGene-810
Before using the QuickGene-810, perform the following tasks:
• Keep clean inside the instrument and parts
• Supply/Replace buffers (wash buffer and elution buffer)
The buffers must be used within one day from when they are set in the QuickGene-810.
Execute the discharge operation when replacing the buffers in the tubes in QuickGene-810.
4.2 When the QuickGene-810 is left for a Week or More
Even after completing the operation and turning off the power, there are buffers (wash buffer, elution
buffer) remaining in the QuickGene-810. When the QuickGene-810 will not be used for a week or more,
the remaining buffers may become crystallized, and cause a clog or damage to the tubes.
Discharge the remaining buffers from the QuickGene-810 and clean the inside with ethanol.
■
Tasks required when the device is not used for a week or more
If the QuickGene-810 will not be used for a week or more after the operation, perform the following
procedures:
（
1
）
Put DNase/RNase free water to both new conical tubes for wash buffer and
elution buffer, and perform the discharge operation.
For the discharge operation, refer to "
（
2
）
Dispose waste buffer of discharge tray.
（
3
）
Put ethanol to both new conical tubes for wash buffer and elution buffer, and
perform the discharge operation.
（
4
）
Turn off the power.
■
Tasks required when the QuickGene-810 is used again (after one week or more)
When using the QuickGene-810 again, perform the following procedures:
（
1
）
Put DNase/RNase free water to both new conical tubes for wash buffer and
elution buffer, and perform the discharge operation.
（
2
）
Dispose waste buffer of discharge tray.
（
3
）
Put wash buffer and elution buffer to both new conical tubes , and perform the
discharge operation.
(4) Perform the extraction operation as usual.
Wear latex gloves and a mask during any maintenance.
BIOHAZARD
Summary of Contents for QuickGene-810
