KC 960.30
Installation instructions
Electrics
WARNING! This appliance must be earthed!
The electrical connection may only be carried out by a
qualified and authorised trained installer.
Statutory regulations and the connection specifications issued by the
local power company must be observed to the letter.
The mains lead cable of your glass-ceramic cooking area must not
come into contact with the oven. Fasten the cable to the wall with cable
clamps.
Safeguard the cooker by means of line-protecting switches, fuses or con-
tactors with at least 3 mm contact opening width.
Switch off the appliance by means of these safety devices before con-
necting, carrying out repair work or replacing the light bulb.
It must not be possible to touch components which are insulated under
operating conditions.
The mains connection box is located on the back of the cooking centre.
–
Fasten the mains lead.
Cable quality: HQ5RR-F or HQ7RN-F.
–
Carry out the connection
in accordance with the
connection diagram.
Appliance should be eart-
hed, reset or the protecti-
on circuit should be
activated according to re-
gulations.
Installation in a fitted kitchen
Be careful during fitting! Do not put or drop edged or pointed tools (scre-
wdriver etc.) on the glass top!
Any cooker hoods or wall cupboards must have a vertical clearance of
at least 650 mm from the hob unit.
The appliance must be installed absolutely horizontally.
The Küppersbusch built-in oven EEB 970 can be fitted underneath the
profi-cooking centre KC 960.30.
The cooker is Y-type design, providing overheating protection for surroun-
ding surfaces (fitted cupboard components). The plastic coating or veneer
must be applied with a heat-resistant adhesive (100 °C). This adhesive pre-
vents the surfaces from warping or working loose.
This appliance can be placed with its back wall and one side wall next to
cupboard or room walls of any height. The other side wall may only be
placed next to a fitted cupboard of the same height at the most.
–
Have you connected the mains lead with the appliance?
–
Using 4.2 x16mm screws, install the supporting rails in horizontal po-
sition on the right and on the left onto the cupboard sides according
to measurements.
–
Fit in the appliance.
–
Fasten the appliance onto the supporting rails using 4.2 x 7 mm
srews.
–
Seal the appliance on the back and on the two sides with silicon.
Element
230 V
L 2
L 1
2
230 V
L 1
3
4
5
1
2
N
1 N
L 2
230 V
230 V
230 V
L 1
L 3
3
4
5
1
2
3
L 2
L 2
230 V
230 V
230 V
230 V
230 V
L 1
L 1
L 3
3
3
4
4
5
5
1
1
2
2
N
N
2 N
3 N
KC 960.30
11
