17
TROUBLE-SHOOTING GUIDE
1. The appliance does not work.
•
Is there a power failure?
•
Is the plug properly inserted in the socket?
•
Is the main switch switched on?
•
Has the fuse blown?
•
Is the thermostat set to • position?
2. The temperature inside the compartments is
not cold enough.
•
Do the doors close properly?
•
Is the appliance installed near a heat source?
•
Is the thermostat correctly set?
•
Is air circulation inhibited?
3. The temperature inside the refrigerator
compartment is too cold.
•
Is the thermostat correctly set?
4. Water collects in the bottom of the
refrigerator compartment.
•
Is the defrost water run-off clogged?
5. The internal light does not work.
First refer to point 1, and then:
•
Unplug the appliance from the mains power
supply.
•
Refer to the instructions and illustration on the
enclosed sheet to access the light-bulb.
•
Check the bulb and replace if necessary.
(E14 type, 15W max).
6. Excessive formation of frost/ice in the low
temperature compartment.
•
Is the low temperature compartment door
properly closed?
Note:
•
Gurgling or hissing noises inside the refrigerating
circuit are quite normal.
AFTER-SALE SERVICE
Before contacting our After-Sale Service:
1.
Try to remedy the problem (see “Trouble-shooting
guide”).
2.
Restart the appliance to see if the fault repeats. If
the fault persists, switch off the appliance and
switch on again after an hour.
3.
If the fault still persists, contact the After-Sale
Service and specify the following:
•
the nature of the problem
•
the model
•
the service number (the number after SERVICE
on the rating plate located on the side of the fruit
and vegetable drawer)
•
your full address
•
your telephone number plus area code.
Note: changes to the door opening direction
carried out by our Customer Service are not
covered in the terms of the guarantee.
INSTALLATION
•
Do not install the appliance near a heat source
(minimum distances: 30 cm from solid fuel or gasoil
stoves, 3 cm from electric ovens and hobs).
•
Install the appliance in a dry and wellventilated
place.
• Do not cover the air vents.
•
Clean the appliance interior (see relevant chapters).
•
Mount the accessories.
ELECTRICAL CONNECTION
• Electrical connections must be made in
accordance with local regulations.
•
Voltage and absorption rates are indicated on the
rating plate.
• The appliance must be earthed as prescribed
by law. The manufacturer declines all liability
for personal injury or damage to property or
animals resulting from failure to comply with
the above requirements.
•
If the appliance plug and wall socket are
incompatible, the socket must be replaced by a
qualified electrician.
•
Do not use extension leads or multiple adapters.
ELECTRICAL DISCONNECTION
•
It must be possible to disconnect the appliance
from the mains by removing the plug or by
disconnecting a two-pole circuit breaker.
