12
Fig. 4
Open the door and
push the
appliance against
the side of the
kitchen furniture
opposite to that of
the appliance
hinges.
Fasten the
appliance with 4
screws provided in the kit included with the
appliance.
Snap vent grill (C) and hinge cover (D) into position.
Fig. 5
Press in the joint
covers between
the appliance and
the kitchen unit.
Fig. 6
Apply covers (B)
on joint cover lugs
and into hinge
holes.
Fig. 7
Position the
runners (H) inside
the kitchen unit
door as shown in
Fig. 8 and mark
the position of
the external
holes.
After preparing
the holes, screw
the runners to the kitchen unit door using 3.5x16
mm screws.
D615
C
D
D616
D096
B
D094
20mm
H
Fig. 8
Open both the
appliance door
and that of the
kitchen unit to
approx. 90
°
.
Place the little
plates over the
runners.
Hold the doors of
the appliance and
the unit together and mark the holes.
Fig. 9
Remove the little
plates and make
the holes with a
diam. of 2 mm.
Replace the little
plates over the
runners and
screw in the
screws provided
(3.5x16 mm).
If the kitchen unit door needs to be re-aligned,
adjust the position of the screws in the slots.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Inner door reversal
Fig. 10
Using a
screwdriver
release bracket
(1) by pressing on
the internal
spring (Fig. 10)
and withdraw it
from its seat
together with the
door;
remove plug (2) and fit it in the hole left open on the
opposite side;
turn the door through 180
°
, remove the bracket (1)
and refit it on the opposite side.
Refit the door and insert the top pin and bottom
bracket (1), pushing it into place.
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the
open position until it is properly closed.
8mm
PR34
PR35
PR140
1
2
180°
