For internal use only
Service Manual GKS 324.0 + GKS 644.0
7
2. Installation Conditions and Assembly
2.1 Notes regarding Installation
• Make sure that the worktop is horizontally aligned and precisely cut out!
• The distances of the hob recess at the front, rear and lateral to the wall must be observed in
accordance with the dimension drawing. In the case of correct minimum distances, wall sealing
strips of solid wood can be used on the worktop behind the cooking zones. The lateral distance
to high cupboards should be at least 300 mm for technical reasons.
• There must be no cross strips below the worktop recess. They have to be cut to at least the
size of the worktop recess.
• In the case of fitted furniture the plastic covering or the varnish must be processed with heat-
resistant adhesive (100 °C).
• The minimum distance of fume exctractors and wall-cupboards above the cooking surface must
be 650 mm.
It is recommended to seal the cutting surface of the worktop recesses for built-in sinks and oven
hobs by water-resistant painting.
2.2 Assembly
KÜPPERSBUSCH built-in hobs can and may be exclusivley combined with KÜPPERSBUSCH
built-in ovens with appliance ventilation. Exception: model series EGS. The use of other brands
excludes any liability by KÜPPERSBUSCH. The granted test marks and approvals become void
in the case of disregarding of this instruction!
In the case of built-under ovens the gas connection bracket located centrally at the rear side
under the appliance has to be twisted to the left-hand or right-hand side.
For this purpose undo the union nut, twist the bracket and tighten the union nut again.
Check for gas tightness.
