13
If the equipment does not work, please
contact the Technical Ser vice Depar tment and
advise them of the problem, indicating:
1
Serial number (S-No)
2
Appliance model. (Model)
You will find this information on the rating
plate on the lower par t of the oven when the
door is opened.
The item that you have bought meets the
European directives on electrical material
safety (73/23/CEE) and electromagnetic com-
patibility (89/336/CEE).
AENOR certifies the aptitude of this appliance
for the function and guarantees the truthful-
ness of all data shown in the energy card.
Technical Information
The installer must check that:
• The voltage and cycles of the mains supply
correspond to that indicated on the rating
plate.
• The electrical installation can stand the
maximum power indicated on the rating
plate.
• The connection diagram is shown in the
following figure.
• The connect the oven to the electrical circuit,
the installer must use a T150 type supply
cable.
• The electrical connection has adequate
ear thing in accordance with regulations in
force.
• The connection must be carried out with an
omnipolar switch, of an adequate size for
the current drawn. There must be a
minimum aper ture between contacts of 3
mm to enable disconnection in the case of
emergency, cleaning or bulb exchange.
Under no circumstances must the ear th
wire pass through this switch.
After connecting the electricity, check that all
the electrical par ts of the oven are working.
Electrical Connection.
Legal Requirements
Installation
This information is intended for the installer,
as the person responsible for assembly and
electrical connection. If you install the oven
yourself, the manufacturer will not be held
responsible for any possible damage.
Installation must only be perfomed by a fully
qualified electrician who must ensure regulations
laid down for installation are observed.
• A niche is required in the kitchen unit as per
the dimensions shown on the figure,
providing a minimum depth of 580 mm.
(See figures describing oven fitting on the
pages 14 and 15).
• The adhesive used for the plastic covering
of kitchen furniture must be able to
withstand temperatures up to 85ºC.
Before Installation. Comments
12
Trouble Shooting
NB
If, despite these recommendations, the pro-
blem continues, contact our Technical
Assistance Ser vice.
The oven does not work
Check the connection to the electrical circuit.
Check the fuses and current limiter
of your installation.
Ensure the clock is in the manual
or programmed mode.
Check the position of the function
and temperature selectors
The inside light of the oven does not work
Change the bulb.
Check its assembly in accordance
with the instruction manual.
The heating indicator light does not work
Select a temperature.
Select a setting.
It should only light up while the oven is heating
up to its set working temperature.
Smoke is given off while the oven is working
This is normal during its first use.
Periodically clean the oven.
Reduce the amount of grease
or oil added to the tray.
Do not use higher temperature settings
than those in the cooking tables.
Expected cooking results are not achieved
Review the cooking tables to obtain guidance on
the working of your oven.
1
3
N
L
