Assembly instructions
GB
13
Clips
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
• Drive the clips into the worktop cut-out at the intervals
indicated. It is not necessary to adjust the height due to the
horizontal stop.
• Important! The horizontal drive of the clips must be flush with
the worktop. (avoid the risk of fractures)
• Position the hob according to the illustration on the left side (a),
align it (b) and insert the clips (c).
• Screws may be used to fasten the clips.
Important!
There is a risk of breakage if the hob is canted or subjected
to stress during installation!
Bracket
Minimum distance to adjacent walls
Cut-out dimension
Outer dimensions of the hob
Cable routing in rear wall
Installation height
• Insert the hob and align it.
• From the bottom, insert the brackets with screws in the holes
provided for fastening the brackets, align the brackets and
screw them tight.
• Tighten the screws with a hand screw driver only; do not use a
battery-operated screw driver.
• In the case of thin worktops make sure that the brackets are
correctly positioned.
Important:
There is a risk of breakage if the hob is canted or subjected
to stress during installation!
Dimensions in mm