Service Manual
5
For internal use only
2.
Accessing the components inside the hood
Two models of the hood are produced: stainless steel with Soft Touch electronic controls and stainless
steel/glass with Touch Control electronic controls.
The middle panels of both models can be opened when pulled out. This gives you access to the
components inside the hood.
The panel is removed by means of the movable hinge peg.
2.1
Removing the controls
1.
Remove the two screws that fasten the front of the hood to its
casing.
2.
Use a small screwdriver to remove the springs on the front (on
the left and right) from the casing section.
3.
Pull out the front.
4.
Screw out the two screws on the back of the front part which
fasten the controls to the clamp.
