background image

4

Installation instructions KC 906.2 USA

Installation above the oven 
EEB 9600.0

The oven must be positioned on a secured shelf be-
tween two cabinets. Shelves (approximately 19mm/ 
9/16" thick) must be attached to the adjacent cabi-
nets on both sides so the oven can be clipped in at 
the sides.

Please review the installation instructions for the 
model EEB 9600 for installation dimensions and in-
stallation.

Be sure to install a 
stainless steel filler panel 
(acc. No. 454) between the 
Cook-Center and the oven. 
The stainless steel filler 
panel is required and sold 
separately.

Electrical connection

■ 

Observe all guidelines and regulations from your local electric code.

■ 

You should not be able to touch insulated components when operating the 
appliance.

■ 

The power supply should be a 240 volts system, 2-wire with ground, or a 
120/240 volts system, 3-wire with ground.

Electrical diagram
for a 240 volts system,
2-wire with ground:

Electrical diagram
for a 120 / 240 volts system, 
3-wire with ground:

■ 

Be sure to install an appropriate conduit box (not furnished) to connect the 
cook top. Only a professional electrician or certified technician should install 
a conduit-box or replace the connection cable.

■ 

Don’t shorten the conduit to facilitate service! The conduit should be routed 
to permit the removal of the cooking surface.

■ 

A circuit breaker or fuse is recommend, having amperage as noted in this 
chapter. Fuse both sides of the line!

■ 

The conduit-box can be mounted under the countertop below the cooking 
surface or in a side cabinet in the wall. Do not mount it above the cooking 
surface!

■ 

Be sure the conduit and the conduit box cannot be touched or damaged 
after installation!

Connection

to a conduit-box (not supplied accessory!)

Total rating

8.3 kW, fuse current: 40 A

Electrical connection

240 V, 60 Hz

Summary of Contents for KC 906.2









Reviews: