Kuppersbusch ITE1370-2, User Manual

Page: 23 / 60

Problem Possible cause Solution
The temperature in the
freezer is too high. The temperature regulator is not
set correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time. Store less products at the same
time.
Products are too near to each
other. Store products so that there is
cold air circulation.
Upper or lower square is
shown in the tempera-
ture display. An error has occurred in meas-
uring the temperature Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
dEMo appears on the
Display. The appliance is in demonstra-
tion mode (dEMo). Keep pressed approximately
10sec the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height 1030 mm
Width 560 mm
Depth 550 mm
Rising Time 26 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the door, you must ensure that it is
made unusable to prevent young
children being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
23