H2-50-02
15
For internal use only
5.2
Mounting the hob
The hob is fitted with a special sealing so that no liquids can get into the unit. The following instructions
must be followed carefully in order to apply the sealing correctly:
•
Remove all the loose parts of the hob.
•
Cut the sealing into 4 parts. They must be long enough to be put on the 4 edges of the glass.
•
Turn the hob around and apply the adhesive side of the sealing “E” (Figure 9) properly under the edge
so that the exterior of the sealing is flush with the outer edge of the glass panel. The ends of the strips
must fit together without overlapping.
•
Glue the sealing evenly and securely onto the glass, pressing it on with your finger.
•
Position the hob in the cut-out that has been made in the unit and use the screws “F” to secure the
fastening hook “G” (see illustration).
•
In order to avoid making accidental contact with the overheated surface of the recess while the hob
is in operation, a shelf must be installed under the appliance with a clearance of at least 70 mm to
the top of the workspace. The shelf may only be removable with tools.
•
Tighten the screws with a hand screw driver only; do not use a battery-operated screw driver.
