background image

What to do if there is a fault

Unplug the appliance befor repair!

Check carefully to make sure that the fault is not due to misoperation. You
can rectify many faults yourself.

Fault

Cause

Remedy

Not possible to
switch off
cooking area.

Failure of
electronic
component.

Switch off cooker fuse in fusebox, 
call service centre.

Cooking area
does not heat.

Fuse is
defective.

Check or replace cooker fuse in fuse
box.

Child proof lock
activated.

Deactivate child proof lock.

Cooking area is
defective.

Call service centre.

Inner circuit of
the dual-circuit
zone is
defective.

Do not operate the functioning outer
circle. Immediately call service centre.

When this point flashes it indica-
tes that the saucepan sensor is
defective. However, you can con-
tinue to use the cooking zone
when the saucepan sensor is
switched off. Manual selection is
necessary for the dual circuit
and frying zones (see page 17).

Important note:

Repairs should only be carried out by an authorised technician!
Even during the guarantee period repairs will not be free of charge if due to
incorrect operation or to non-adherence to our instructions given under
“What to do if there is a fault”.
You should always give the data on the rating plate to your service centre in
case you have enquiries or want to order spare parts. The rating plate is
located underneath the cooking area and on the title page of these instructi-
ons.

Cleaning and care

Never use sharp or abrasive agents!

It is sufficient to clean with a damp
cloth and a little washing-up liquid af-
ter usage.
Wipe dry.

Incrustation due to boilied over foods
are best presoftened with a wet cloth.
Then remove them with a glass scra-
per. Sugar and melted plastic should
be removed while the cooking area is
still hot.

Clean the glass-ceramic cooking area after every use. Always keep the
sensor keys clean, since soiling could be detected as finger contact by
the aplliance. Immediately remove soiling. Never put anything (pans, tea-
towels etc.) on the sensor keys! If food boils over onto the sensor but-
tons, we advise you to activate the emergency switch.

Care for your glass-ceramic cooking area once a week.
Regular care builds up a protective layer and also eases day to day clea-
ning. Please follow the instructions of the cleaner or cleanser manufactu-
rer concerned. Even heavy soiling can be cleaned with a cleanser and
enough water. Wipe dry with a cloth.

If cleaning agents are applied too heavily, they can burn and cause fu-
mes, polluting the air in the kitchen. For this reason please make sure
that all cleaning agents are thoroughly removed after cleaning!

EKE 807.2

21

Summary of Contents for EKE 807.2













Reviews: