Kuppersberg TS 61, Technical Passport

Page: 6 / 19

10 11
Technical passporT english english Technical passporT
gas hob gas hob
uSable SOuCePaN DiameTer
Wok Burner Ø 24 - 28 cm
Rapid Burner Ø 22 - 26 cm
Semi-rapid Burner Ø 18 - 22 cm
Auxiliary Burner Ø 12 - 18 cm
Smart burner Cell (Optional)
1- Cooking time is adjusted by turning the control knob to the right (Example:
30 mins.) as below
2- After the time is adjusted, press the burner control knob and turn it to the
left (counterclockwise) to the fl ame symbol and ignite burner. After the burning
commences, make the safety system go on by keeping the knob pressed down for
5–10 seconds.
3- If the burning does not take place after you press and release the knob, repeat
the 2nd step.
4- After the duration that was set in the timer, the fl ame on the burner will be
automatically cut off and a notifi cation “bing” sound will be heard. End the process
by turning the control knob of the smart burner to ( ) position.
WarNiNG:
Time setting is not possible when the knob on position with hand mark C .
burner runs forever.
Using cooktop for Hot Plates(Optional):
Hotplate power table for 3 levels
Ø145 mm
LEVEL 1
250 W
LEVEL
2
750 W
LEVEL
3
1000 W
Ø 180 mm 250 W 1100 W 1500 W
Hotplate power table for 6 levels (Optional)
Hot Plate LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4 LEVEL 5 LEVEL 6
Ø145 mm 95 W 155 W 250 W 400 W 750 W 1000 W
Ø 180 mm 115 W 175 W 250 W 600 W 850 W 1500 W
Ø 145mm Rapid 135 W 165 W 250 W 500 W 750 W 1500 W
Ø 180mm Rapid 175 W 220 W 300 W 850 W 1150 W 2000 W
1. Electric hotplates have standard of 3 or 6 temperature levels (as described
herein table)
2. When using fi rst time, operate your electric hotplate in maximum position for
5 minutes. This will make the agent on your hotplate which is sensitive to heat get
hardened by burning.
3. Use fl at bottomed saucepans which fully contact with the heat as much as
you can, so that you can use the energy more productively.
4. Adjust temperature level by control knob of hotplate as turn to clockwise
direction.
Nozzle change operation for gas burners:
1. First of all please close all gas supply of cooker. Please use driver with special
head for removed and install nozzle.
2. Please remove nozzle from burner with special nozzle driver and install new
nozzle