Kuppersberg NRB 17761, Manual, Page: 8 / 48

8
Technical passporT english
refrigerator nrB 17761
2a. Remove the lower hinge pin P
and the distance spacer D.
2b. Remove the lower door.
2c.
Slide off hinge cover H; remove
the middle hinge C, then free the upper
door.
2d. Remove the upper hinge pin K
and t it to the opposite side.
2e. Remove the central support L.
2f.
Re t the upper door.
2g. Fit hinge C and support L on the
left side. (The hinge cover H, must be
re tted at the end of installation).
2h.
Re t the middle support L on the
right side.
2i.
Re t the lower door.
2l. Insert pin P and spacer D.
2m. Remove the door opening/
closing elements S and reassemble
them on the opposite side.
INSTALLATION
IN THE TALL UNIT HOUSING
The dimensions of the tall unit
housing must correspond to those
reported in the gure.
3a. Insert the appliance in the
housing against the side panel
adjacent to the opening. Check that the
side of the appliance is inset 53 mm in
the unit.
3b. Adjust the foot until the top
panel is not in contact with the unit.
3c. Anchor the upper part of the
appliance, using the screws supplied,
in the pre-drilled panel over the front
fascia.
3d. Anchor the centre of the
appliance to the wall of the unit using
the special brackets.