Kuppersberg HGG 663 B, Technical Passport

Page: 13 / 36

13
English TEchnical passporT
gas oven
CONVERSIONS
BURNERS
GAS
NORMAL
PRESSURE
mbar
NORMAL
RATE
INJECTOR
DIAMETER
1/100mm
NOMINAL HEAT
INPUT (W)
№ DESCRIPTION g/h Min. Max.
1 OVEN
BUTANE G30
PROPANE G31
28-30
37
174
171
78(C)
78(C)
1100
1100
2400
2400
2 GRILL *
BUTANE G30
PROPANE G31
28-30
37
160
157
73
73
–
–
2200
2200
Maintenance And Cleaning
CLEANING
Always allow the appl’ance to cool
down before cleaning to avoid a burn
injury Do not use caustic or abrasive
agents, coarse wire wool or hard tools as
these can damage the surface fi nishes.
Normally, wiping with a soft cloth
dampened with hot detergent is
suffi cient, but for stubborn marks the
following is recommended;
Vitreous Enamel Parts
Use only a cleaner thet is
recommended for this type of
metarialavoid chloride-based products
such as bleach.
Door Glass
Do not use any abrasive medium
thet could cause damage, Rem ember
that if the surface of the glass panel
becomes scratched, this could lead to a
dangerous failure.
To facilitate cleaning, the door glass
can be lifted out after removing the
fi xing screws, Whwn refi tting, make sure
that the glass is correctly seated in the
door recess and the correct way round.
Cane must be taken when cleaning
between the door glasses, and inside
the inner frame as some of the edges
maybe sharp due to the manufacturing
process.
WARNING
Â
Take care not to dislodge the
hinge lock system when removing the
door as the hinge mechanism has a
strong spring system!
Â
Do not immerse the door in
water at any time.
Changing the Oven Bulb
Caution
To change the bulb, fi rst ensure
that the oven is disconnected from the
power supply.
Â
Unscrew the lens from the lamp
holder.
Â
Exchange the bulb and replace
the lens. The replacement bulb must
300“C These can be ordered from the
Technical Service Department.
TABLE