Kuppersberg GS 6057, Manual

Page: 48 / 120

48
TECHNICAL PASSPORT ENGLISH
Dishwasher
appliance should not be inclined more
than 2°.
NOTE: The maximum adjustment
height of the feet is 20 mm.
How to Drain Excess Water From
Hoses
If the sink is 1000mm higher from
the floor, the excess water in hoses
cannot be drained directly into the
sink. It will be necessary to drain excess
water from hoses into a bowl or a
suitable container that is held outside
and lower than the sink.
Water Outlet
Connect the water drain hose. The
drain hose must be correctly fitted to
avoid water leaks. Ensure that the water
inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension,
observe to use a similar drain hose..
It must be no longer than 4 metres;
otherwise the cleaning effect of the
dishwasher could be reduced.
Syphon Connection
The waste connection must be at
a height of between 50cm (minimum)
and 100cm (maximum) from the bottom
of the dish. The water drain hose should
be fixed by a hose clip.
7. Start of Dishwasher
The followings should be checked
before starting the dishwasher:
1. Whether the dishwasher is
level and fixed
2. Whether the inlet valve is
opened
3. Whether there is leakage at the
connections of the conducts
4. Whether the wires are tightly
connected
5. Whether the power is switched
on
6. Whether the inlet and drain
hoses are knotted
7. All packing materials and
printings should be taken out from the
dishwasher
Attention
After installation, please put this
manual into the bags of printings.
The content of this manual is very
helpful to the users.