14
GEMINI 100 User Manual
_April 2013 Edition
Machine adjustment procedures
Abrasive assembly procedures
1.
Ensure the electric cable is disconnected to the power.
2.
Turn the machine over, resting the handles on the floor.
3.
Remove the worn abrasive paper discs from the velcro-
backed discs.
4.
Ensure the surface of the velcro-backed discs is clean and
position new
100 mm diameter
abrasive discs.
5.
Attach the abrasive disc securing it well to the velcro.
Adjusting the working surface on the floor
The discs operate best when slightly tilted with respect to
the floor.
Tilt is determined by the position of the wheel support
which is fitted at the rear of the conveyor.
To change the inclination of the discs
loosen the Allen nut and let the support
slide on the sanded surface, then tighten
the nut once the required height has been
reached.
Routine maintenance to be performed
To keep the machine in good working condition the following items must be checked and serviced regularly:
Sawdust chamber (for the user)
Hoover the sawdust from the chamber regularly to prevent
the hazardous accumulation of dust.
