22
bona.com
Bona Belt Lite Manual
Starting the Machine (Cont.)
If starting the machine is difficult in winter when temperatures are very low remove the abrasive belt and start the
motor, letting it idle for several minutes. Replace the belt and repeat the start up operations described.
12)
Observe the operation of the abrasive belt. Follow the procedures for
'Centering The Abrasive Belt'
on page 23. The belt must run inside the
tensioning unit
(A)
and protrude by approximately 2mm from the rubber drum
(B)
.
13)
Close the side guard
(A)
.
14)
After lowering the lever
(A)
, commence sanding.
15)
To stop the machine:
Turn
the knob
from “1” to “0”
A safety contactor is fitted to the machine. If the power fails when sanding the contactor is activated
automatically, stopping the machine from accidentally starting up when the power is restored. To
recommence sanding repeat the start-up operations described above.
Summary of Contents for Bona Belt lite
Page 1: ...Operating Manual Bona Belt Liteby ...
Page 32: ...bona com 01 2016 Edition ...
