3
ASSEMBLY INSTRUCTIONS
Read the complete assembly instructions before starting the assembly.
You should have:
- one cultipacker assembly
- one wheel kit (optional)
- one 3-point kit (optional)
The standard pull type Model TP2148, TP2760 and TP3272 Cultipackers are fully assembled and
ready for use after uncrating. If the optional wheel kit was purchased with the cultipacker please see
Section A for assembly instructions. If the optional 3-point kit was purchased with the cultipacker
please see Section B for assembly instructions.
CAUTION:
Removing the cultipacker from the crate should be performed with caution.
Care should be taken to prevent back injuries or other lifting related injuries.
A.
ASSEMBLY OF OPTIONAL WHEEL KIT (See Figure 1)
1. Remove the 5/8” nut and lock washer from each wheel assembly. All other hardware should
stay on the wheel assembly in the order that is shown in Figure 1.
2. Insert the end of the wheel assembly bolt through the cultipacker frame and install and
securely fasten the 5/8” nut and lock washer that was removed in Step 1.
Figure 1. – Wheel Kit Assembly
Cultipacker Frame
Mounting Hole
5/8” Nut & Lock Washer
5/8” Flat Washer (Large)
Cup Washer
5/8” Flat Washer (Small)
5/8” Bolt