13
CAUTION:
The engine full speed setting with mower blades running is 3350 RPM.
For Model H60B:
Set the choke to the desired position.
Set the throttle lever in the start position at about half throttle. The mower blades clutch will
engage as the engine comes up to speed. The mower blades clutch engages at 1850 RPM.
Start engine and allow engine to warm up.
Adjust the choke to off.
Adjust engine speed to full throttle to fully engage the mower blades clutch.
CAUTION:
Clutch overheating or failure may occur if engine is not run at full speed in
heavy load conditions.
CAUTION:
The engine full speed setting with mower blades running is 3350 RPM.
For Model H40B:
Set the throttle lever in the
choke
position to set the choke. (The throttle lever is located on the
right side of the engine.)
Start engine and move throttle toward
slow
position to disengage choke.
Slow engine speed and engage mower blades clutch handle. (The clutch handle is located at
the front of the mower under the engine.)
Note:
Some belt squealing may occur on engagement. This is normal for a manual clutch
engagement design.
CAUTION:
If the mower’s engine happens to quit while in use take care to remove the
wing mower from the uncut area before attempting to engage the clutch. Also inspect the
blades for any obstructions that may prevent blade engagement. Failure to do either may
result in premature belt failure or even a fire.
Adjust engine speed to
fast
position for full throttle. (The full throttle is located at the detent
position on the throttle control.)
Summary of Contents for AcrEase H60B
Page 2: ...cbxcbxcvb...
