12
13
KCHS4852 IX
KCHS4852 WH
EN
visor cooker hood
Horizontal ventilation:
See Pic A, please use the tool to knock out
the outlet cover on the top, then the air can be vented from top.
Vertical ventilation:
See Pic B, please use the tool to knock out the
outlet cover on the back, then the air can be vented from back.
2.1.2 Air ventilation setting
Outdoor air ventilation:
Turn the adjuster to outdoor position (pic A),
install the outlet, turn on the cooker hood, then the air will be vented
from the outside outlet.
Indoor air ventilation:
Turn the adjuster to indoor position (pic B),
install the outlet cover, turn on the cooker hood, then the air can be
vented from the inside outlet.
WARNING:
Failure to install the screws or fixing the device
in accordance with these instructions may result in electri-
cal hazards.
2.2. Using the Product
2.2.1. Operation
How to use the control panel (See Pic 8):
a. Press the button “Stop”, the motor will stop.
b. Press the button “Low”, the motor will run at low speed.
c. Press the button “Mid”, the motor will run at medium speed.
d. Press the button “High”, the motor will run at high speed.
e. Press the button “Light”, both lights will switch on. Press the button
again; the lights will switch off.
Pic 8
Changing the light
Warning: The LED light should be replaced by a competent
person! If the LED light is damaged, contact the Customer Support
Service for assistance.
1. Remove the grease filter.
2. Loosen the 2pcs ST4*8mm self-tapping screw from the lamp
plate, take out the lampplate.
3. Disassembly the 3pcs ST3*12mm screws on the terminal box
cover and take down the wire cover.
4. Pull out the terminal from the PCB terminal block, disconnect
the wire connector and replace the light.
• ILCOS D code for this lamp is: DBS-2/65-H-120/33
– Max wattage: 1×2 W
– Voltage range: AC 110-240V
– Dimensions:
2.2.2. LED Light
