18
19
KC6455
EN
refrigerator freezer
Note:
This appliance performs well within the climate class n, ST or n, ST,
T showed in the table below.
It may not work properly if being left at a temperature above or below
the indicated range for a long period.
Climate class
Ambient temperature
Sn
+10° C to +32° C
n
+16° c to +32° c
ST
+16° c to +38° c
T
+16° c to +43° c
• Keep the appliance out of direct sunlight, rain or frost. Stand the
appliance away from heat sources such as stoves, fires or heaters.
Levelling of appliance
• For sufficient levelling and air circu-
lating in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. you can adjust them
manually by hand or by using a suita-
ble spanner.
• To allow the doors to self-close, tilt the
top backwards by about 10mm.
Remove and install the door shelf
Warning:
The door shelf must not be removed and installed by the
user! If the door shelf is damaged, contact the customer helpline
for assistance. To replace the door shelf, the below steps can be
followed:
Remove the door shelf
Press the right side of the door shelf in-
ward, while holding the left side. When
the shelf notch has been detached
from the refrigerator door, remove the
rack diagonally upwards.
Install the door shelf
firstly, tilt the left side of the door shelf
and make sure the notch has been fas-
tened to the door. Then press the right
side inwards and push it down to the
right place.
Reversing the door
The side at which the door opens can be changed, from the right side
(as supplied) to the left side, if the installation site so requires.
Warning!
When reversing the door, the appliance must not be
connected to the mains. Ensure that the plug is removed from the
mains socket.
Note:
Before you start laying the refrigerator on its back in order to
gain access to the base, you should rest it on soft foam packaging or
similar material to avoid damaging the backboard of the refrigerator.
To reverse the door, the following steps are generally recommended.
1.
Stand the refrigerator upright. open the upper door to take out all
door racks (to avoid damage to the racks) and then close the door.
2.
Remove the Upper hinge cover (right)
, then
remove the screws
, and remove part
. Put
the just detached part
back in the plastic
bag, place screws
and part
on the side
for use.
Note:
Please hold the upper door during step 2 to prevent the door
from dropping.
3.
Remove the upper door and place
it on a smooth surface with its panel
upwards. loosen screws
, and
remove part
, then install part
to the left side with screws
.
4.
loosen screws
used to fix the middle
hinge
and remove middle hinge
.
Then remove the lower door.
5.
Place the lower door on a smooth surface
with the panel facing upwards. loose
screws
, and remove part
, then install
part
to the left side with screws
.
6.
Change screw hole covers on middle cover plate
from left to right (as shown in figure below).
7.
Place refrigerator flatwise, remove
part
and then loose screws
.
Remove parts
,
and part
.
