Gateway component Sercos
19 / 23
5.3 Sercos Configuration
Prerequisite:
You are logged in as "Admin" on the webserver (s.
section "Logging into Webserver").
Illustration 8:
Settings for Sercos
You can make the following settings for Sercos:
Value
Default Use
Sercos Address 64
Device address for the gateway component.
You can set an address in a value range
between 1 and 511.
Connection
Length Leaving
Slave
18
Determines the maximum lengths of the data
transferred cyclically between the Sercos
Master and gateway component.
This value containss 4 bytes of control data.
Note!:
If the input and output data of the partner
gateway component is shorter than these val-
ues, then they will also be shortened accord-
ingly on the Sercos Bus.
Connection
Length Towards
Slave
18
Configuration
