Section K- Proper Draft Information
(
continued..)
appliance and chimney connector joints. An uncontrollable burn or a glowing red stove
part or chimney connector indicates excessive draft. A poor draft can cause poor stove
performance and can be remedied with a positive connect or chimney liner. Consult your
dealer for help. KUMA stoves are approved for use with or without liner connect in
properly constructed, clay-lined masonry chimneys.
Section L- K-400 Free-Standing Wood Stove
Installation Instructions
If this wood stove is not properly installed, a house fire may result. To reduce the
risk of fire, follow the installation instructions. WARNING: Do not compromise
clearances, codes, or materials used. Contact local building or fire officials about
restrictions and installation inspection requirements in your area.We also recommend that
your Kuma model HT wood stove be installed by a properly trained and licensed installer,
preferably an NFI (National Fireplace Institute) expert.
*PARTS REQUIRED
:
1) Model K-400 wood stove– 8” flue
2) Floor protector
3) Chimney connector (stovepipe)
4) Chimney
(Refer to figure 5)
a. Chimney sections
b. Fire stop
c. Support box
d. Storm collar
e. Roof flashing
f. Chimney spark arrestor cap
USE ONLY 8” DIAMETER CHIMNEYS THAT HAVE BEEN TESTED TO
ALL APPLICABLE U.L. 103-HT STANDARDS.
*
Floor Protector
-
The floor protector must be non-combustible and must be a minimum
of 46” wide and 48” deep (U.S.) and 46” wide and 50” deep (CAN.). Situate heater on floor
protector according to the following:
Dimensions
: At least 18” of floor protector in front of the
stove and at least 8” beyond each side of the door opening. Floor protector shall be large enough
to cover under the flue pipe and 2” beyond each side of the flue connector (
see figure 4).
*
Chimney Connector
-
Use chimney connectors (flue pipe) that has been approved for
use with this appliance. The connector shallbe 8” in diameter, and made of steel, 24 gauge
thickness minimum. The chimney connector shall be slipped inside the flue of the stove and
should be screwed to the flue for maximum safety. Each chimney connector section should be
fastened securely together with screws. Approved double-wall connector may be used for
reduced clearance applications (see figs. 2 and 3).
(continued…)
6