20
|
TIG HF
n-coder
JOB Mode
The function allows saving of user programs. There are 10 free storage positi-
ons that can be overwritten at will.
Saving the user program
Press the n-coder for about 2 seconds. Select “S” on the display and press the
n-coder to confirm. Then select storage position 1-10 and confirm with the
control n-coder.
n-coder
n-coder
Loading the user program
Press the n-coder for about 2 seconds. Select “L” on the display and press the
n-coder to confirm. Then select the recording position (1-10) and confirm with
the n-coder.
n-coder
n-coder
Cooling unit connection
MAKin C316W liquid cooling can be connected to the MAKin 320 TIG HF. Coo-
ling is controlled and fully powered by the machine. Observe the instructions
in the MAKin C316W Cooling Instruction Manual for operation. The use of
water cooling must be manually activated by the user by switching the
control button to the position as shown in the figure.
Switching button
Deactivation of liquid cooling
Activation of liquid cooling
Welding in TIG method
1.
Connect the welding accessories. Welding torch on the pole (-), groun-
ding cable on the pole (+), connect the protective gas.
2.
Turn the inverter on by the main switch. Set the welding method TIG and
set the welding parameters according to the above procedures.
3.
Press the button on the torch.
4.
Release the button on the torch to end the welding process.
Welding process at TIG HF
(pic. 1)
1.
Approaching the tungsten electrode to the welded material.
2.
Press the button on the torch - high frequency (HF) to ignite the arc.
3.
Welding process.
4.
Finishing the welding process and activating the DOWN SLOPE function
is done by releasing the button on the torch.
5.
End of the welding process. The digital control automatically switches off
the welding process. Activation of the function POST GAS.
