- 15 -
- Attach inner swath board (S) (photo 8 a) in place with
3 cup square bolts (T) (M 10 x 20), 3 flat washers (dia.
11 x 24 x 2) and 3 self locking nuts (M 10).
Tighten all swath board bolts (T).
6. Installing outer disc with cone and outer swath wheel
- Attach the outer disc with cone using 4 hexagon
screws (M 12 x 20) and 4 conical spring washers
(position the conical centre at the top) so that its
largest diameter is positioned at a right angle in
relation to the adjacent disc (see pictorial opposite).
Tighten at 12 daNm (90 ft.lbs).
- Attach swath wheel assembly (U) to outer skid shoe
(photo 9) with 2 cup square bolts (V) (M 12 x 35), 2
conical washers (dia. 13 mm) and 2 self-locking nuts
(M 12).
Torque : 8.5 daNm/65 ft.lbs
Before tightening screws (V), make sure that swath
wheel does not come into contact with cone cover or
knives.
Keep to a distance of
X = 15 to 25 mm / 3/5" - 1"
.
The angular position of the swath wheel compared to the cutterbar can be adapted to working conditions
enabling a regular flow of the cut crop towards the rear.
Position the swath wheel so that
maximum angle (A')
(fig. 9 A) is obtained. In difficult working
conditions (long, dense, bent over crops) position it towards
minimum angle (A)
(fig. 9 A).
All manuals and user guides at all-guides.com
