KUHN AXIS 20.1, Operator'S Manual

Page: 60 / 216

Standard operating procedure (all models) 8
48
AXIS-GENERAL
8.5.3 Hopper mounting heights A and B as per the spreading calibration chart
The hopper mounting heights in the calibration chart (A and B) are always meas-
ured in the field from the top of the crop height to the bottom edge of the frame.
Setting the mounting height during normal fertilisation
Requirements:

The solid fertiliser broadcaster should be connected to the tractor at the high-
est connecting point of the steering arm.

The lower arm of the tractor should be connected to the upper coupling
point of the lower steering arm of the solid fertiliser broadcaster.
Proceed as follows when determining the hopper height (in normal fertilisation):
1. Determine the hopper heights A and B (above crop) from the calibration
chart.
2. Compare the hopper heights A and B (plus the crop height) with the maxi-
mum approved hopper mounting heights at the front (V) and rear (H).
NOTICE
The values of A and B are taken from the calibration charts .