KUHN AXIS 20.1, Operator'S Manual

Page: 24 / 216

Safety 3
12
AXIS-GENERAL

Never clear blockages in the broadcaster hopper by hand or with the foot but
always use a suitable tool. To prevent blockages always use the safety guard
when filling the hopper.

Before cleaning the solid fertiliser broadcaster with water, steam or other
cleaning agents cover all components that must be prevented from getting
wet (e.g. bearings, electrical connections).

Check the nuts and bolts regularly for tightness and tighten loose contacts.
3.9 Traffic safety
When travelling on public roads and tracks the tractor with the attached solid fer-
tiliser broadcaster must comply with the traffic regulations of the country in which
it is operating. The owner and driver are responsible for compliance with these
regulations.
3.9.1 Checks before driving
A pre-operational check is an important contribution to traffic safety. Before every
trip check compliance with the operating conditions, traffic safety and the regula-
tions of the country of operation.

Make sure that the approved total weight is not exceeded. Note the approved
axle load, the approved braking load and the approved tyre load capacity;
See also „Axle load calculation“ on page 29 .

Is the solid fertiliser broadcaster correctly attached?

Could spreading material be lost while travelling?
-
Check the fill level of the fertiliser in the hopper.
- The metering slides must be closed.
- The locks must also be closed on single-action hydraulic cylinders.
- Turn off electronic controls.

Check the tyre pressure and the function of the tractor brake system.

Do the lighting and identification markings on the solid fertiliser broadcaster
comply with the your country regulations for use on public roads? Make sure
to make the fittings according to the regulations .