KUHN AXIS 20.1, Operator'S Manual

Page: 181 / 216

Maintenance and repair
169
C
AXIS
20.1
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
AXIS 50.1 W
C.5 Metering slide adjustment
Check that the metering slides open evenly before every working season and
during the season if necessary.
Requirements:

The mechanics must be freely movable to check the metering slide setting.

Actuator is disengaged.
Running the test (example on left side of spreader):
2. Push the metering slide against the pin.
 The pointer must point to 85 on the metering slide scale. If position is
not correct, the scale must be adjusted.
n
WARNING
Danger of crushing and shearing!
Power-operated components (adjustment lever, metering
slide) may crush and shear when working on them.
Pay attention to the shear points of the metering outlet and
slides during all adjustment work.
 Turn off tractor. Remove the ignition key.
 Do not operate hydraulic slide actuators during adjust-
ment work.
1. Take a lower link pin d = 28
mm and insert it centrally
into the outlet.
Figure 18: Lower link pin in metering outlet